Image

H2F treated framing: Disposing of a myth

6 April 2021

It has been suggested that the reuse of H2F framing at the end of a building’s life may pose a substantial problem in 20-30 years. This article explains the nature and benefits of H2F framing, why the suggested timeline is too short and why the magnitude of the problem has been over-estimated.

H2F treated framing, easily recognised by the distinctive blue colouring, was developed to prevent termite attack, a potential problem in improperly constructed buildings in some areas of Australia.

It has long been recognised that it is far less expensive to exclude termites than control them and complete repairs once they infest a structure. Once they have entered, termites can not only damage timber, including framing, joinery and furniture, but will eat other cellulose-based materials, even the paper covering on plasterboard.

The traditional approach to termite protection was to create a chemical barrier, drenching the soil with a long-lasting insecticide (chlordane was a major one). Houses were also built with exposed surfaces so any termite attempts at access (e.g. mud-tubes) could be easily detected. Mechanical barriers, such as mesh, are also used to prevent termite ingress.

Today, many of the long-lasting soil poisons are no longer available and those that are provide reduced periods of protection, often less than 10 years, and need to be reapplied to continue to protect the building.

The softwoods which are used for most timber framing in Australia, are not naturally termite resistant. The H2F process coats the dry timber with a thin layer of an insecticide, with added blue colouring to make it easily recognisable on the job site.

The H2F treatment uses one of three insecticides: bifenthrin, permethrin or imidacloprid. Permethrin (which is widely used to treat scabies and lice on humans) and bifenthrin are pyrethroids, which are related to natural products found in chrysanthemums. Imidacloprid is a neonicotinoid, which is related to the nicotine found in tobacco. All are effective at very low levels, have exceptionally low toxicity to humans and repel termites, providing protection for the life of the structure, typically 50 years or more. Retrofitted houses that retain the H2F treated timber frame and update other features will continue to benefit from its protection. Many currently occupied timber framed homes in Australia were built in the 1800’s.

It has been suggested that the disposal of H2F framing at the end of a building’s life may pose a problem. At present, there are few economical pathways for disposal of any framing timber other than landfill or composting. This situation can be expected to change as the market embraces and applies the concept of a circular economy in which there is a much greater focus on the retrieval and reuse of materials.

The Centre for Timber Durability and Design Life at the University of the Sunshine Coast is currently working on ways to improve the reuse of timber, while the timber industry is looking to identify national approaches to recovery and reuse that avoids landfills.

H2F framing was introduced relatively recently, so at the moment there is very little entering the waste stream. However, for the H2F treated timber that does enter the waste stream It is important to consider the amounts of chemical in these timbers and the risks they pose as well as the relative rates of degradation in a typical municipal solid waste facility.

The Australian Standards (AS/NZS-1604) for H2F treatment specify slightly different amounts for each of the three chemicals to slightly different depths in the timber. The amounts of any one of the three chemicals in the timber is extremely low. This clearly differentiates these shallow, low level treatments for indoor use from those used for heavy duty outdoor protection such as chromated copper arsenate (CCA) that may have very different disposal pathways.

It is technically feasible to compost H2F treated timber. The extremely small amounts of chemicals in the H2F treatments tend to bind to soil and organic particles in the ground where they degrade over a period of days to months, depending on the environmental conditions.

The other likely option is landfill. Nearly all modern municipal solid waste facilities are lined and the waste is tightly compacted and covered. This creates an essentially anaerobic (oxygen free) environment in which little to no degradation of timber occurs. Examinations of timber excavated from older landfills shows little evidence of any degradation. The presence of small amounts of insecticide would have little or no effect on these processes.

To summarise, the disposal or repurposing of H2F treated timber is similar to that of most types of timber, the small amounts of chemicals in the H2F treated timber have a negligible effect on the process. The benefits of H2F treated timber in replacing toxic chemical soil drenches to provide long-lasting protection and increasing the durability and service life of our homes significantly outweigh any other potential issues.

Source: Jeffrey J. Morrell, Professor and Director, National Centre for Timber Durability and Design Life

Read More
Image

Mapping Gisborne’s worst eroding land

Gisborne land adaptation shifts have received positive feedback from both the Eastland Wood Council and an environmental group. The region’s farmers and forestry companies might end up with designated land they can’t operate on under new council plans. Council chief ...
Read more
Image

Canadian developed Hydrogen-diesel system secured

HVMS, a leading provider in the decarbonisation of transportation, has announced the establishment of its partnership with Canadian company Diesel Tech Industries, to establish installation facilities for the Guardian Hydrogen Diesel System. This initiative marks a significant step towards advancing sustainable ...
Read more
Image

Australian timber framing industry gets a boost

Forest and Wood Products Australia (FWPA) is set to spearhead an initiative highlighting the advantages of timber framing in construction, promising a significant boost to its promotion efforts. First established in the Australian Forest Products Association’s Softwood Manufacturing Chamber, and funded by ...
Read more
Image

Who’s transforming our economy with renewable resources?

The opportunities for converting forestry fibre to renewable resources to replace fossil fuel based products are growing every year. The adoption of bioenergy and related technologies / products in New Zealand and internationally, sourced from forestry and wood products companies ...
Read more
Image

New trade agreement a boost for NZ wood processors

Increased export opportunities through the removal of tariffs for 41 wood products included within the ‘Agreement on Climate Change, Trade and Sustainability’ is welcomed by New Zealand’s wood processing and manufacturing industry. ‘Under brand New Zealand we have a leading story to ...
Read more
Image

Södra to become the largest producer of kraft lignin in the world

As a step in the strategy of getting more out of every tree, Södra is now establishing a new business to become a world leader in the production of kraft lignin. Södra’s production facility will be the first commercial facility ...
Read more
Image

NZ National Exotic Forest Description survey – data needed

On 1 April 2024, the Ministry for Primary Industries (MPI) sent out the 2024 National Exotic Forest Description (NEFD) survey. The survey is critical for informing wood availability forecasts, which underpin infrastructure and wood processing investment decisions, as well as contributing to a ...
Read more
Image

Unlimited potential of virtual reality for forest thinning

How a virtual reality (VR) and gaming engine could add another tool to the forestry training kit. A future where new foresters are trained to thin trees from the safety of a virtual reality forest before more advanced real-world training could be ...
Read more
Image

Growing the potential of NZ’s forestry sector in partnership

Forestry Minister, Todd McClay, has announced the start of the Government’s plan to restore certainty and confidence in the forestry and wood processing sector. “This government will drive investment to unlock the industry’s economic potential for growth,” Mr McClay says. ...
Read more